GE Profile CustomStyle PTC22MBM Specification Sheet

TM
PTC22MBM – GE Profile
Case Dimensions (in inches/cm.)
Front View
69-7/8
68-3/4
38-1/4
35-3/4
23-3/4
26-3/4
28-3/8
Top View
Specification Revised 1/03
™ 21.9 Cu. Ft. CustomStyle
Rough-In Dimensions (in inches/cm.)
12"
Soffit
70-1/4"*
61 24"
Cabinet
24-1/2"* Side panels
™ Top-Freezer Refrigerator
Standard, New Construction and Replacement Installation
8' Ceiling

Installation Tips to Maximize the Built-In Look

• All wall/floor moulding should be removed prior to installation.
• Water recess on rear wall recommended to prevent water line damage.
13" to 14"
Cabinet
• When possible, recess both copper water line and electrical outlet.
• Front and rear leveling legs are adjustable for the built-in look.
Handle Side Clearance
Top and Bottom Clearance
Hinge Side Clearance
• To avoid door contact to countertop consider:
24"
36"
Water Electrical
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
25"
Counter
Top
For answers to your Monogram,
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
48" minimum length 1/4" diameter water line tubing recommended.
(See local codes)
(See owner's manual)
– At least 2" (51 mm) on the handle side for fingertip clearances.
– At least 3/16" (4.75 mm) at the top and bottom edges to allow for trim flange.
– The installation of 3/4" (19 mm) thick side panels requires less clearance
because the space between the door and adjacent countertop is wider.
– Miter the corner of the adjacent countertops 45°, or pull the refrigerator
forward enough to avoid contact.
IMPORTANT:
Before finalizing specifications for your GE Profile Performance
CustomStyle ™ Refrigerator, Please NOTE:
• A minimum of 36" is required for refrigerator installation
• Be sure to allow for 1/2" or 3/4" side panels in addition to the 36" minimum
Total volume and shelf
area are calculated by the
Association of Home
Appliance Manufacturers'
R
standards.
® GE Profile
® service, 800.626.2000.
™
Listed by
Underwriters
Laboratories
™ or