Connecting Speakers - Bosch PLE-2MA120-EU Installation And User Instructions Manual

Plena Mixer Amplifier | Installation and User Instructions | Connections and settings
4.2.5

Connecting speakers

4.2.5. 1 Constant voltage loudspeakers
figure 4. 1 0: Connecting speakers
The mixer amplifier can drive 100 V constant voltage
loudspeakers.
Connect the loudspeakers in parallel and check the
loudspeaker polarity for in-phase connection. The
summed loudspeaker power should not exceed the
rated amplifier output power.
You can use the Call Only output for 3-wire remote
volume control override. You can also use this output as
an extra zone where announcements can be heard, but
not music.
Bosch Security Systems | 2007-10 | PLE-2MA120-EU, PLE-2MA240-EU en
4.2.5.2 Low impedance loudspeakers
figure 4. 1 1: Connecting speakers
Connect low impedance loudspeakers to the 8 Ohm/0
terminals. This output can deliver the rated output
power into an 8 Ohm load. Connect multiple
loudspeakers in a series/parallel-arrangement to make
the combined impedance 8 Ohm or higher. Check the
loudspeaker polarity for in-phase connection.
en | 22