Ultra Start 35 SERIES Owner's Manual page 9

2WAY REMOTE STARTER
LCD DISPLAY
User programmable features
This Feature allows the user to program system features from the transmitter. The
following icons will be displayed on the LCD to determine the status of the feature.
To Enter User Program Mode
1. Press and hold button #4 for three seconds. The Timer Icon will begin to flash,
the system is now in User Program Mode.
2. Press button #1 to scroll the list of features. Selected feature icon will begin to
flash. Press button #2 to turn the feature icon Off, Press button #3 to turn the
feature icon On. Press button #4 to exit program mode and save settings.
*If the remote is not used for 20 seconds the system will exit Program Mode.
TIMER ICON- When this icon is displayed in the left program column if
confirms that the Timer Mode has been programmed ON. When this icon
is turned on in remote program mode the Cold Start feature will be
activated. Cold Start will default to the last time or temperature setting.
KEY ICON- When this icon is displayed the remote starter has
encountered a start fault. The start fault must be corrected before the
remote starter will activate again.
HORN ICON- This icon indicates the status of the horn output.
If the icon is on, the horn will work normally. If the icon is not displayed
the horn feature is off and the horn will not honk.
SHOCK SENSOR ICON - N/A
SERVICE MODE ICON- This icon indicates the status of the Service
?
Mode feature. If this icon is present, the system is in Service Mode.
*While in Service Mode, only the keyless entry features will operate.
VIBRATION/SOUND ICON- This icon indicates the status of the
Vibration and Sound features of the transmitter. If the icon is on, the
remote will vibrate and not beep. (Not on all Models)
To activate this feature press and hold buttons #3 and #4 four 5 seconds.
OWNER'S GUIDE
Page 9