Key To Symbols; Symbols On The Machine And/Or In The Man Ual - Husqvarna 440 e-series Owner's Manual

Symbols on the mac hine and/or in
the manual:
W ARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Chain brake, activated (right)
Chain brake, not activated (left)
Decompression v alve: The valve
is to reduce the pressure in the cylinder
and make starting easier. You should
always use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
1153159-95 Rev .2 2010-04-08
KEY T O SYMBOLS
Switch off the engine before
carrying out any checks or
maintenance. NB! The start/stop
switch automatically returns to run
position. In order to prevent
unintentional starting, the spark
plug cap must be removed from
the spark plug when assembling,
checking and/or performing
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged
when the chain saw is started.
–
English 7