Advertisement
ZISW/B420DX
GE Monogram
Water Filter
Dimensions and Installation Information (in inches)
1/4" Framed Panel
Dimensions
If you choose to install framed
panels, they must be cut to the
dimensions shown. The panels will
slide into the frame on the door and
grille.
If the custom panel is less than 1/4"
thick, and it fits loosely in the door
frame, it can be backed up with a
piece of filler material or foam tape
to improve the fit.
Important Note:
Maximum total panel weight:
• Fresh food door panel – 75 lbs.
• Freezer door panel – 53 lbs.
• Grille panel – 18 lbs.
Dispenser Cutout
15-3/8"
9-5/8"
194Dia_63
For answers to your Monogram,
®
or GE
appliance questions, visit our website
at ge.com or call GE Answer Center
800.626.2000.
®
42" Built-In Side-by-Side Refrigerator with Dispenser and
Door
39-7/8"
194Dia_59
Grille Panel
17-13/16
Dispenser
Cutout
3-1/8"
Freezer
Fresh
Panel
Food
14-9/16"
24-9/16"
®
™
GE Profile
®
service,
Dispenser Models
These refrigerators are supplied with two dispenser trims,
5/16"
one for framed panels and one for overlay panels.
Trim
Reveal
1/4" Framed Panel
The framed panel must be 1/4" nominal thickness to fit the
dispenser trim.
1/4"
Panel
• The dispenser trim fits over the custom panel and snaps
into the freezer door.
• If the panel is less than 0.250" thick, a noticeable gap may
be created around the dispenser trim. Foam tape may be
applied on the door to improve the fit.
• If the panel is more than 0.250" thick, the dispenser trim
cannot be secured to the door.
1/4"
Framed
9-1/2"
Panel
3/4" Overlay Panels
The overlay dispenser trim is designed to fit a total panel
thickness of 1.100" .
• If the panel is less than 1.100" thick, a noticeable gap may
68-3/8"
be created around the dispenser trim.
• If the panel is more than 1.100" thick, the dispenser trim
cannot be secured to the door.
• The overlay panel must be constructed according to the
specifications shown to achieve the correct total thickness.
• Alternative panel construction methods such as securing a
3/4" panel to a 1/4" backer panel cannot be used. Another
method, routing a 3/4"-thick panel on all sides, cannot be
used. These methods will not result in the required 1.100"
panel thickness.
• When a raised panel design is to be used, a custom middle
rail is required.
1/4" Backer Panel
.10" Spacer
Panel
3/4" Overlay
Panel
FREEZER DOOR
Ice / Water Dispenser
1/4" Dispenser Trim
696Dia3
FREEZER DOOR
Ice / Water Dispenser
3/4" Overlay Dispenser Trim
Listed by
Underwriters
696Dia4
Laboratories
Specification Created 3/08
0.250"
Thick
1.100"
Total
Thickness
®
As an EnErgy StAr
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
110172
Advertisement
