Epson EasyMP Network Projection Operation Manual page 13

Connecting to a Projector on a Network and Projecting
When the system starts in Advanced Connection Mode.
A
Automatic search
In Quick Connection Mode, you can search for the projectors based on
the SSID.
In Advanced Connection Mode, you can search for available projectors
on the network system to which the computer is connected.
B
Manual search
In Quick Connection Mode, you can search for the projector based on
the SSID selected from a list.
In Advanced Connection Mode, you can search for a projector based on
a specified IP address or projector name.
C
Status
The following seven icons indicate the status of the detected projectors.
Standby Available.
Busy
Busy (Disable
interrupt con‐
nection)
Currently in
use by another
application
Searching
Not found.
Not acquired
D
Projector name
The projector's name is displayed.
E
Update list (Quick Connection Mode only)
Updates Status and Signal intensity.
F
Disable interrupt connection
Select this to prevent an interrupt connection by other computers while connected
to the selected projector.
G
Use multi-display
Select this when using the Multi-screen display function. When this is selected,
Display layout and Display properties are displayed at the bottom of the screen.
s "Using Multi-Screen Display" p.26
H
Troubleshooting
If there is a problem and you cannot have a connection, press this button to open
the EasyMP Network Projection Troubleshooting screen.
I
Connect
Connect to the projector you selected from the search results list. When a
connection is made with a projector, a toolbar is displayed.
Available. When you click Connect, the
computer currently connected is
disconnected and your computer is
connected.
Cannot be selected. Disable interrupt
connection is set on another computer
which is already connected.
The projector's Configuration menu is
open. You can select it after closing the
Configuration menu and running the
search again.
Displayed while running Manual search or
Profile.
Displayed when a projector cannot be found
as a result of Manual search or Profile.
Available. Displayed when a projector with
security settings enabled is found in Quick
Connection Mode.
13