GE 200D2600P031 Owner's Manual And Installation page 6

About the temperature controls.
About TurboCool
6
The temperature controls are preset in the factory at 5 for both the refrigerator
and freezer compartments. Allow 24 hours for the temperature to stabilize to the
preset settings.
Several adjustments may be required. Each time you adjust controls, allow 24 hours
after each adjustment for the refrigerator to reach the setting you have selected.
Setting either or both controls to 0 stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
Control settings will vary based on personal preferences, usage and operating
conditions and may require more than one adjustment.
NOTE: The refrigerator is shipped with protective film covering the temperature
controls. If this film was not removed during installation, remove it now.
Ambient Room Temperature Limits
This refrigerator is designed to operate in ambient temperatures specified
by its Temperature Class, which is marked on the rating plate.
Temperature Symbol
Class
Extended-
Temperate
Temperate
Subtropical
Tropical
NOTE: Internal temperature may be affected by such factors as the location of the refrigerator, ambient temperature
and frequency of door openings. Adjust temperature controls as required to compensate for these factors.
™ .
How it Works
TurboCool rapidly cools the refrigerator
compartment in order to more quickly cool
foods. Use TurboCool when adding a large
amount of food to the refrigerator compartment,
putting away foods after they have been sitting
out at room temperature or when putting away
warm leftovers. It can also be used if the
refrigerator has been without power for an
extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and off
at high speed as needed for eight hours. The
compressor will continue to run until the
refrigerator compartment cools to approximately
1°C, then it will cycle on and off to maintain
this setting. After 8 hours, or if TurboCool is
Ambient Temperature
Maximum
SN 32°C
N 32°C
ST 38°C
T 43°C
pressed again, the refrigerator compartment
will return to the original setting.
How to Use
Press TurboCool. The TurboCool indicator
light will come on.
After TurboCool is complete, the TurboCool
indicator light will go out.
NOTES: The refrigerator temperature cannot be
Minimum
10°C
16°C
18°C
18°C
changed during TurboCool.
The freezer temperature is not affected
during TurboCool.
When opening the refrigerator door
during TurboCool, the fans will continue
to run if they have cycled on.