Weslo Purcuit4.2 Bike Manual page 11

10. Hold the Handlebar (53) near the Upright (13).
Insert the two Pulse Wires (67) into the Upright,
and then pull the Pulse Wires out of the top of
the Upright.
Tip: Avoid pinching the wires. Attach the
Handlebar (53) to the Upright (13) with two M8 x
65mm Bolts (36), two M8 Curved Washers (46),
and two M8 Locknuts (10).
11. The Console (16) can use four AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Remove the battery cover from the back of the
Console (16), and insert batteries into the battery
compartment. Make sure to orient the bat-
teries as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
10
10
46
13
11
16
11
67
53
36
Avoid pinching
the wires
Battery
Cover