8. Have a second person hold the Upright (13) near
the Frame (1) until step 9.
Connect the Extension Wire (52) to the Reed
Wire (43).
Then, connect the Resistance Cable (19) to the
Lower Resistance Cable (45) in the following
way:
• See drawing A. Pull upward on the metal
bracket on the Lower Resistance Cable (45),
and insert the tip of the Resistance Cable (19)
into the wire clip inside the metal bracket.
• See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket.
• See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
9. Insert the excess wire and cable into the
Frame (1).
Tip: Avoid pinching the wires. Slide the
Upright (13) onto the Frame (1).
Attach the Upright (13) with three M8 x 20mm
Screws (34) and three M8 Split Washers (42).
8
B
A
Metal
Bracket
19
45
9
Avoid pinching
the wires
34
42
10
13
19
45
52
1
43
C
Metal
19
Bracket
13
34
42
1