Assembly - Weslo Momentum 410 Elliptical User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver
wrench , a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST on page 14. The number following the
parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a
part is not in the parts bag, check to see if it has been preassembled.
M5 x 10mm M8 Nylon
Screw (69)–2 Locknut (58)–8
M7 Washer M8 Split
(83)–2
Washer (63)–8
M10 Split M10 Washer
Washer (62)–2
M8 x 20mm Button
Screw (85)–8
M10 x 70mm Carriage Bolt (51)–4
M10 Nylon
Locknut (53)–6
Offset Washer
(78)–2
Crank Axle Spacer
(77)–4 (75)–2
M8 x 45mm Button
Bolt (74)–4
, and pliers
Left Crank Axle Right Crank Axle
Nut (76)–1
M8 Curved M8 Washer
Washer (82)–12
M10 Acorn Cover
(72)–4
M8 x 45mm Hex
Bolt (84)–4
4
, an adjustable
.
M8 Acorn Cover
Nut (43)–1
M10 Curved
Washer (80)–4
(81)–4
M7 x 22mm Button
Screw (65)–2
M10 x 20mm
Screw (70)–2
Barrel Bolt (39)–2
(73)–8