Flue Assembly - Installation; Internal Access Flue - Saunier Duval Xeon 50ff Instructions For Use Installation And Servicing

4.12 Flue Assembly - Installation

If the boiler is not to be fitted for some time cover the hole in the
wall.
On limited access installations push the flue assembly into the
hole such that it is within the wall and does not stick out into the
room, see diagram 4.12. Do not push the flue assembly too far
into the hole as it has to be pulled back into the boiler and
secured.

4.13 Internal Access Flue

If access to the outside wall is not practical, the flue system can
be installed from inside. Use of the optional wall liner kit is
required.
WITH WALL LINER KIT ONLY
FOAM
SEAL
10mm
WALL THICKNESS-
UP TO 300mm
WALL THICKNESS-
OVER 300mm
4 Flue and Appliance Preparation
Q
FOAM
SEAL
Q-25mm
Q
Diagram 4.11
GASKET
(PRE-ATTACHED)
FOAM
SEAL
REAR FITTING
SIDE FITTING
17


 
Diagram 4.12


   

 

   
 

    


Diagram 4.13
"A"
Diagram 4.14
FOAM
SEAL
221658B