Clock And Timer - GE JGBC18 Use And Care & Installation Manual

Standard- and continuous-clean models
Table of Contents

Advertisement

Follow the directions below
clock and timer shown at the right.
You have the choice of having the timer show the
time counting down or the time of day. In either case,
the timer will signal at the end of the timer period to
alert you that the time is up.
To Set the Clock
NOTE: When you first plug in the range or after a
power failure, the entire C1oc~imer display will light up.
1. Press the CLOCK pad.
2. Press and hold the+ or – pad and the time of day
will change 10 minutes at a time. To change the
time by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Change or Cancel the Timer Setting
When the timer is counting down, use the+ and – pad
to change the remaining time, or press the TIMER
ON/OFF pad to stop the timer. The timer cannot be
instructions above.
Clock
Follow these directions if
your range has the clock and
timer shown at the right.
To set the clock, push in the
knob and turn it to the right.
Let the knob out when the
clock hands reach the correct
time. Continue turning the
knob to OFF.
(on some models)
if your range has the
12
4
/,
,
.
20
.
, , \
/
CLOCK
(Appearance may vary)
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Use the + and – pads to set the timer. Short taps on
the + or – pad change the timer's setting one minute
at a time. Pressing and continuing to hold the + pad
increases the setting ten minutes at a time.
3. Once you have set your timer, press the TIMER
ON/OFF pad to start timing.
As the timer counts down, a signal will indicate
when one minute is left. After this signal, the display
will count down in seconds. When time runs out, a
final signal will sound. Press the TIMER ON/OFF
pad to stop the signal.
Display Clock While Timer Is Operating
Pressing the CLOCK pad while the timer is operating
will not interfere with the timer's operation; the
display will change to show the clock, but the timer
will continue to count down and will still signal when
time is up. Press the TIMER ON/OFF pad again to
change the display back to show the timer.
Timer
The timer has been combined with the range clock.
Use it to time all your precise cooking operations.
You'll recognize the timer as the pointer that is
different in color than the clock hands.
30, and hours are marked
Minutes are marked up to
up to 4 on the center of the clock.
To set the timer, turn the knob to the left—without
pushing in—until the pointer reaches the number of
minutes or hours you want to time.
At the end of the set time, a buzzer sounds to tell
you time is up. Turn the knob—without pushing
in—until the pointer reaches OFF and the buzzer stops.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents