Assembly - Reebok Rtx455 User Manual

A
ssembly
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver and rubber mallet
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (69) until the treadmill is in the position shown.
Insert one of the Extension Legs (102) into the treadmill
as shown. Make sure that the Extension Leg is turned so
the Base Pad (99) is on the bottom. Note: It may be help-
ful to tip the Uprights (69) forward as you insert the
Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
2. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two of the four 3/4"
Screws (100). If there are square rubber bumpers on the
bottom of the Uprights (69), remove them.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included.
If a Base Pad becomes worn and needs to be replaced,
use the replacement Base Pad.
3. Remove the Handrail Extension (66) from the Right Foam
Grip (75), which has a large cutout in the left side. Insert
the Handrail Extension into the post on the right Upright
(69) as shown. Note: Be careful not to pinch the wires
in the Upright. Make sure the wires in the post are cen-
tered. Align the holes in the Handrail Extension with the
holes in the post. If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Next, attach the
Handrail Extension by tightening two Small Screws (67)
into the indicated holes.
Slide the Right Foam Grip (75) as far as possible onto the
post on the right Upright (69). It may be helpful to apply
soapy water to the Handrail Extension (66).
.
1
2
69
110
99
3
Cutout
75
6
69
102
99
99
69
102
100
102
67
66
Post
Wires
100
69