Reebok Rt1000 User Manual page 7

4. With the help of a second person, tip the Uprights (82)
down as shown. Make sure that the Extension Legs
(103) and the Handrails (74) remain in the Uprights.
Insert a Handrail Bolt (78) with a Handrail Washer (48)
into each Extension Leg (103) and tighten the Handrail
Bolts into the Handrails (74). The Handrail Bolts should
be inserted at right angles to the base of the Uprights
(see drawing 4b).
If it is difficult to align the hole in a Handrail (74) with the
hole in one of the Uprights (82), move the Handrail up or
down, or have a second person stand on the treadmill
and lift the Handrail as shown in drawing 4c.
Refer to drawing 4. Attach each Extension Leg (103)
with two Screws (76), as shown.
Note: One replacement Base Pad (97) may be included.
Use the extra Base Pad if one becomes worn or needs
to be replaced.
With the help of a second person, carefully raise the
treadmill back to the upright position.
5. Refer to drawing 5. Locate the left Rear Foot (59) on the
treadmill. If the left rear foot touches the floor, go to step
6. If there is space between the left Rear Foot and the
floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position (see page 18).
Using a phillips screwdriver, remove the Rear Foot
Screw (60), the right Rear Foot (59) and the Rear Foot
Spacer (8). Reattach the right Rear Foot without the
Rear Foot Spacer. Hold the treadmill with both hands
and lower the treadmill (see page 18). Re-check the left
Rear Foot (59). If the left Rear Foot is still off the floor,
raise the treadmill and remove the left Rear Foot. Snap
the Rear Foot Spacer (8) onto the left Rear Foot and
reattach the left Rear Foot. Carefully lower the treadmill.
6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.
4
82
76
74
103
48 78
97
4c
82
74
103
5
59
5b
59
60
76
48
78
103
4b
48
78
74
103
8
7