Table of Contents
Advertisement
11. Insert three 45mm Square Inner Caps (40) into the
ends of the Leg Lever (17). Insert a 25mm Round
Inner Cap (39) into the weight tube on the Leg
Lever. Press a 25mm Angled Outer Cap (38) onto
the other end of the weight tube.
Attach the Leg Lever (17) to the Adjustable Bench
Leg (2) with an M10 x 70mm Bolt (21) and an M10
Nylon Locknut (11). Do not over tighten the M10
Nylon Locknut; the Leg Lever must pivot easily.
12. Insert 19mm Round Inner Caps (26) into the ends
of the three Pad Tubes (16).
Insert two Pad Tubes (16) through the holes in the
Leg Lever (17). Slide a Foam Pad (25) onto each
side of the Pad Tubes.
Insert a Pad Tube (16) through the upper tube on
the Adjustable Bench Leg (2). Slide a Foam Pad
(25) onto each side of the Pad Tube.
13. Attach the Curl Pad (8) to the Curl Upright (9) with
two M6 x 16mm Screws (3).
14. Make sure all parts are properly tightened
before you use the weight bench. The use of the
remaining parts will be explained in ADJUSTING
THE WEIGHT BENCH on pages 13 and 14 of this
manual.
11
40
Weight
Tube
39
40
12
26
25
25
26
25
17
13
9
21
2
40
38
17
2
16
25
25
8
3
9
11
26
Advertisement
Table of Contents
