KTM 990 SUPER DUKE R EU Owner's Manual page 145

15 COOLING SYSTEM
–
Remove the radiator cap and pour in coolant until it emerges without bubbles at the
vent hole, and then immediately mount and tighten the bleeder screw
Guideline
Remaining chassis screws
Alternative 1
Coolant (
Alternative 2
Coolant (mixed ready to use) (
B00223-10
–
Fill the radiator completely with coolant. Mount the radiator cap.
–
Lean the vehicle on the side stand.
–
Check the coolant level in the compensating tank. (
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
–
–
Start the engine and run it until it reaches operating temperature.
Six bars of the temperature display light up.
–
Stop the engine and allow it to cool down.
–
When the engine is cool, check the coolant level in the radiator and add coolant if nec-
essary.
–
Check the coolant level in the compensating tank. (
Finishing work
–
Install the spoiler. (
p. 186)
p. 186)
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
p. 79)
.
1
M6 10 Nm (7.4 lbf ft)
p. 139)
p. 139)
143