NordicTrack E 5.5 Elliptical Manual page 11

12. Identify the Right Pedal (14) and orient it as
shown.
Attach the Right Pedal (14) to the right Pedal
Arm (12) with three M8 x 50mm Screws (112).
Attach the Left Pedal (not shown) to the left
Pedal Arm (12) in the same way.
13. Apply a small amount of grease to a Long Pedal
Arm Axle (106) and to an M8 x 23mm x 1.5mm
Washer (91).
Next, partially tighten an M8 x 16mm Screw
(102) and the M8 x 23mm x 1.5mm Washer (91)
into one end of the Long Pedal Arm Axle (106).
While a second person holds the end of the right
Pedal Arm (12) inside the bracket on the Right
Upper Body Leg (6), insert the Long Pedal Arm
Axle (106) through both parts.
Partially tighten another M8 x 16mm Screw (102)
and an M8 x 23mm x 1.5mm Washer (91) into
the Long Pedal Arm Axle (106). Then, tighten
both Screws at the same time.
Repeat this step on the other side of the
elliptical.
14. Identify the Right Inner and Outer Leg Covers
(27, 28) and orient them as shown.
Press the Right Inner and Outer Leg Covers
(27, 28) together around the Right Upper Body
Leg (6).
Attach the Right Inner and Outer Leg Covers
(27, 28) to the Right Upper Body Leg (6) with an
M4 x 16mm Screw (93). To avoid damaging the
plastic, do not overtighten the Screw.
Attach the Left Inner and Outer Leg Covers
(49, 50) in the same way.
12
12
13
12
14
50
11
14
12
112
6
102
91
106
Grease
91
49
6
93
27
102
28