NordicTrack E 5.5 Elliptical Manual page 10

9. Attach the Rear Upright Cover (24) to the Upright
(5) with four M4 x 16mm Screws (93).
10. Attach the Front Upright Cover (25) around the
Upright (5) by pressing the tabs on the Front
Upright Cover into the Rear Upright Cover (24).
11. Identify the Short Pedal Arm Axles (115) and the
Long Pedal Axles (not shown).
Apply a small amount of grease to a Short Pedal
Arm Axle (115) and to an M8 x 23mm x 1.5mm
Washer (91).
Next, partially tighten an M8 x 16mm Screw
(102) and the M8 x 23mm x 1.5mm Washer (91)
into one end of the Short Pedal Arm Axle (115).
Orient a Pedal Arm (12) as shown. While a sec-
ond person holds the end of the Right Pivot Arm
(51) inside the bracket on the Pedal Arm, insert
the Short Pedal Arm Axle (115) through both
parts.
Partially tighten another M8 x 16mm Screw (102)
and an M8 x 23mm x 1.5mm Washer (91) into
the Short Pedal Arm Axle (115). Then, tighten
both Screws at the same time.
Repeat this step on the other side of the
elliptical.
9
5
24
10
24
11
102 91
Grease
115
51
10
93
25
5
12
91
102