Shutdown Of A Single Unit In A Parallel System - GE Digital Energy LP 33 Series Operating Manual

7.2.4

Shutdown of a single unit in a parallel system

With purpose to separate one unit from the parallel system.
1. Switch OFF the inverter only on this unit entering the screen:
MENU/COMMAND MENU/INVERTER OFF
Attention: to switch OFF permanently the inverter the key
Enter must be pressed 2 times.
2. Switch OFF the output switch Q1 (0) only on this unit.
3. Perform the command total off only on this unit.
4. Switch OFF battery breaker only from battery cabinet belongs to this unit.
5. In order to discharge the DC link capacitors, start once more
the inverter only on this unit through the screen:
MENU/COMMAND MENU/INVERTER ON
Remark: command INVERTER ON will be enabled only when
the inverter voltage of each phase decreases
below 7 VAC (about 30 seconds).
Before proceeding to step 6, check on the display panel that
the DC link voltage (both polarities) Udcp and Udcn has reached
the minimum voltage of 5 VDC (about 30 seconds).
6. Switch OFF the inverter only on this unit entering the screen:
MENU/COMMAND MENU/INVERTER OFF
7. Switch OFF the mains power only on this unit at the AC input distribution panel.
WARNING !
In case the unit should be disconnected and removed from the operating system, the
operation must be performed by qualified persons.
If an intermediate unit must be disconnected from a parallel system pay attention
do not open the control bus: keep the plugs J3 and J4 connected to the board "P16 -
Connector adapter RPA" (see Section 4.8.4).
Modifications reserved
OPM_LPS_3UO_50K_60K_0US_V010.doc
END OF PROCEDURE
COMMAND MENU
INVERTER ON
INVERTER OFF
COMMAND MENU
INVERTER ON
INVERTER OFF
INVERTER: U1= 7V
U2= 7V U3= 7V
Frequency = 60.0Hz
Synchronized
Udcp= 5V Udcn= 5V
Ubp=0V Ubn=0V O
Charge level = 0%
Autonomy = 0min
COMMAND MENU
INVERTER ON
INVERTER OFF
Operating Manual LP 33 Series 50 & 60 kVA
*
*
*
Page 48/57