Installation Instructions; Freestanding Outdoor Grill Installation - KitchenAid 720-0733 (LP) Installation Instructions And Use & Care Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack Grill
1. Remove all packaging materials and remove grill from the
shipping base.
2. Move grill close to desired outdoor location.
3. Open the grill hood.
Remove Packaging Material Inside the Grill
1. Use a utility knife to cut yellow straps and packing tape to
open box from top and remove the boxes.
2. Remove the warming shelf and grill grates from inside the grill
and remove the package inside the firebox.
3. Remove foam block and wrap from inside the grill.
Attach Right Side Shelf with Sear Burner
1. Unpack right side shelf with sear burner.
2. Open grill lid.
3. Remove 3 screws from the side of the searing side burner.
A
A. Searing side burner screws
14

INSTALLATION INSTRUCTIONS

Freestanding Outdoor Grill Installation

4. Remove the screws from the central post, then 2 screws on
the grill side panel and 1 screw on the grill control panel.
A
A. Grill control panel screw
B. Grill side panel screws
5. Lower the side shelf so that the center post (A) slides into the
bracket (B) and align the bottom keyhole slots on the side
shelf with the screw holes on the grill side panel.
IMPORTANT: This step is meant to help with the installation, but
do not depend solely on the bracket to hold the weight of the
sear burner.
6. Attach the top of the side shelf to the grill (A) by inserting the
3 screws removed in Step 3 into the side shelf from inside the
grill hood and tighten. See illustration in Step 8.
7. Attach the bottom of the side shelf to the side panel (B and C)
of the grill by inserting the 3 screws removed from the grill
side panel in Step 4. The drip pan may need to be pulled
forward to install the center screw (C). Tighten the screws.
See illustration in Step 8.
B
A
B