Sequence Of Gas Metal Arc Welding (Gmaw); Sequence Of Flux Cored Arc Welding (Fcaw); Sequence Of Gas Tungsten Arc Welding (Gtaw); Sequence Of Air Carbon Arc Cutting And Gouging (Cac-A) - Miller Electric GPS-500 Owner's Manual

4-7. Sequence Of Gas Metal Arc Welding (GMAW)

Install &
Connect Connect MOG
Equipment
Turn On Feeder
And Welding
Power Source

4-8. Sequence Of Flux Cored Arc Welding (FCAW)

Install &
Install & Prepare
Connect
Wire Feeding
Equipment
Begin Welding

4-9. Sequence Of Gas Tungsten Arc Welding (GTAW)

Install & Install & Connect
Connect High-Frequency
Equipment
Set Controls

4-10. Sequence Of Air Carbon Arc Cutting And Gouging (CAC-A)

Install & Install & Connect
Connect MOG System
Equipment
Insert
Electrode
Into Torch
OM-266 Page 18
Install & Install & Prepare
Wire Feeding
System System
Begin Welding
Install &
Connect
MOG System
System
Install &
Connect MOG
Unit System
Turn On
Shielding Gas
Connect
Compressed
Air Supply
Turn On
Compressed Welding Power
Air Supply
Put On
Personal Safety
Equipment
Put On
Personal Safety
Equipment
Select
Tungsten
Turn On Turn On
High-Frequency Welding Power
Unit Source
Select
Carbon
Electrode
Turn On Begin
Cutting Or
Source Gouging
Turn On
Set Controls Shielding Gas
Turn On Feeder
Set Controls And Welding
Power Source
Insert Put On
Tungsten Personal Safety
Into Torch Equipment
Begin Welding
Put On
Personal Safety Set Controls
Equipment
ssb6.1* 9/92
ssb8.1* 9/92
ssb8.1* 9/92