Section 4 − Installation; Serial Number And Rating Label Location; Specifications; Gun Recommendation Table - Miller Electric SuitCase X-TREME 8 HD Owner's Manual

4-1. Serial Number And Rating Label Location

The serial number and rating information for this product is located inside the cover. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.

4-2. Specifications

Welding
Type of
Power
Input
Source
Power
Type
Constant
Open-Circuit/ Voltage (CV)
Or Constant
Arc Voltage,
Current (CC)
14 − 110
Volts DC DC Power
Source Only
*Maximum gun length is 10 ft. for solid steel .062 in. wire.

4-3. Gun Recommendation Table

Process
GMAW − Hard or Cored Wires
FCAW − Self-Shielding Wires

4-4. Equipment Connection Diagram

1
2
3
4
5
OM-246 828 Page 12
SECTION 4 − INSTALLATION
Wire Feed Wire
Speed Diameter
Range Range
*Solid Steel:
.023 − 5/64 in.
25 − 780 ipm (0.6 − 2.0 mm);
(1.3 − 19.8 Stainless Steel:
mpm) .023 − .052 in.
Depending On (0.6 − 1.3 mm);
Arc Voltage Flux Cored:
.030 − 5/64 in.
(0.8 − 2.0 mm)
Input
Max. Wire
Welding IP
Circuit Rating
Capacity
Rating
330 Amperes
10 lb (4.5 kg),
At 60% 23
8 in. (203 mm)
Duty Cycle
Bernard Q300 or Q400
Dura-Flux With 12 in. Head Tube
10
8
7
6
Overall
Spool
Dimensions
Length: 18 in.
(457 mm)
Width: 7-1/4 in.
(184 mm)
Height: 12-3/4 in.
(324 mm)
Gun
!
Turn Off wire feeder and
welding power source. Stop
engine on
generator.
!
Use only with CC/CV DC
Power Sources.
1 Constant Current (CC) or
Constant Voltage (CV)
Welding Power Supply
2 Weld Cable To Feeder
3 Work Cable To Workpiece
Weld cable and work cable connec-
tions to power source (DCEN/
DCEP) are dependant on wire type.
.
Since feeder is not polarity sen-
sitive, there is no need for an
electrode polarity switch.
4 Workpiece
5 Voltage Sensing Clamp
9
Connect voltage sensing clamp to
workpiece.
6 Gun
7 Gun Trigger Receptacle
8 Wire Feeder
9 Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant
on wire type.
.
Shielding gas pressure not to
exceed 100 psi (689 kPa).
Weight
30 lb
(13.6 kg)
welding
Ref. 804 419-A