Table of Contents
Advertisement
Everything you need to boot this
motherboard is included in this Easy
Installation Guide. For more
information, a complete
Online User's
Manual
can be found in the
Pack CD
Disc. Thanks for the help of
saving our earth.
Hard Drive IDE Cable x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Bonus Pack CD disc x 1
This Easy Installation Guide x 1
COM2 Cable x 1
PART NO: 49.88A01.004
DOC. NO: MX3SP-EG-E0102D
Normal Operation
Bonus
JP14 Clear CMOS
1
1
2
2
3
3
Clear CMOS
(default)
JP28 Keyboard/Mouse Wakeup
You can clear CMOS to restore system default setting.
To clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pins 1-2.
5. Connect ATX power cable back to connector PWR2.
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
This jumper is used to enable or disable Keyboard/Mouse
Wake Up function. If you select Enable, you can decide the
wake up mode from BIOS Setup > Integrated Peripherals >
Power On Function. To implement this function, the power
supply 5V standby current must be greater than 800mA.
Note that only PS/2 mouse supports Wake on Mouse
function.
1 2 3
1 2 3
Disable
Enable
Advertisement
Table of Contents
