Mode Button; Band Button; Tuning Control - Naxa NX-671 Instruction Manual

CARE FOR USING CD'S:
Ò É Ä Ñ ½ â ³ ý
About CD-R/CD-R/W discs:
In addition to commercially-recorded audio CD's, this unit can play CD-R and
CD-R/W discs. In come cases, particularly when recorded on older CD burners,
some CD-R and CD-R/W discs may not play. Also, whenever you are recording
a CD for playback in this receiver, it is recommended that you record at 24x or
slower speed for CD-R and 4x or slower for CD-R/W to achieve higher signal
quality and better playback performance.
1. To keep the disc clean:
Do not attach any sticker or adhesive tape on the disc.
Handle the disc by its edge to keep the disc clean and do not touch the surface.
Before playing a disc, wipe it off with a clean, dust-free cleaning cloth.
Wipe the disc outwards from the disc center.
2. When one has already been inserted. Doing so may damage the unit
with labeled surface up, or it will damage the unit.
3. Do not expose the disc to direct sunlight or nearby heat sources such as heating vents,
caliduct which can cause the disc to warp.
Do not leave disc in a car if it is parked in direct sunlight as that will lead to a
considerable rise in the temperature inside the car.
4. Do not use any secondhand or rented disc, usually, there is glue on the surface of
those discs, it will stop the unit working and damage it.
5. Always store the disc in its case for protection. Scratched up discs will produce poor
sound performance and cause CD player to skip.
6. In raining day or wet area, the moisture may form on the disc or the optical parts, The
playback may not be possible. If moisture forms on the disc, wipe it off with a soft cloth.
If moisture forms on the optical parts of the unit, allow the unit to sit for about one hour
with power on.
7. Do not use solvents such as benzine or thinners. Commercially available cleaners or
anti-static spray will damage the unit.
. Inset a disc
Page 7

9. MODE BUTTON

Press the MODE(MODE) button to select RADIO, DISC (if disc is loaded
into the disc slot) or AUX mode.
Tuner Controls

1. BAND BUTTON

In radio mode, press the BAND(BND) button switches the receiver from AM to
FM or vice versa. The icon of the selected band will be visible on the display.

2. TUNING CONTROL

Rotate this knob at radio mode to select the desired radio broadcasting station.
The selected frequency will appear on the LCD display.
3. ST/MON BUTTON (This operation is effective on FM reception only.)
During radio mode, press this button to change between mono and stereo
modes. The character ST will appear on the LCD display while there is a strong
signal from an FM station that is broadcasting in stereo. Mono improves the
reception of the distant stereo FM stations.
4. LOC/DXBUTTON (This operation is effective on FM reception only.)
In RADIO mode, press the LOC button toggles between local or distant FM
reception. Pressing LOC will improve reception in some areas where the signal
is too strong. LOC will appear on the LCD display indicating you are in the local
reception mode. Press it again to release it to improve distant reception when
you are located in an area with a weak signal.
Page 4