Wiring Diagram; Location And Function Of Controls - Naxa NX-671 Instruction Manual

WIRING DIAGRAM

ANTENNA PLUG
FUSE 7A
YELLOW
CONSTANT B+
BLACK(GND)
FUSE 0.5A
IGNITION SWITCH
RED (B+)
+
WHITE
FRONT
-
WHITE/BLACK
LEFT
SPEAKER +
GREEN
-
REAR
GREEN/BLACK
Note:
1. Make sure you use a speaker with 4 ohm load impedance
2. Make sure the auto antenna wire (Blue) does NOT come into contact with
the vehicle chassis.
CAUTION:
In order to protect power IC from being burnt out during installation the car stereo,
it is necessary to follow the steps below to connect the wires during installation:
Step 1: Connect the ground wire (Black);
Step 2: Connect all speaker wires and power antenna wire (Blue):
Left speaker
Front speaker: White (+) White/Black (-)
Rear speaker: Green (+) Green/Black (-)
Step 3: RCA Line Out (R- Red/ L-White).
Step 4: Connect Back up (Yellow) and Acc wire (Red)
Page 9
RCA OUTPUT LINE RED R
WHITE L
FUSE 0.5A
BLUE AUTO ANT
+
FRONT
GRAY
-
GRAY/BLACK
RIGHT
+ SPEAKER
VIOLET
-
REAR
VIOLET/BLACK
Right speaker
Gray (+) Gray/Black (-)
Violet (+) Violet/Black (-)

LOCATION AND FUNCTION OF CONTROLS

1. OPEN Button(OPEN)
2. Power(POWER) button
3. CD SLOT
4. LCD DISPLAY
5. EJECT(EJECT) key
6. Volume up/menu up(+) button
7. Volume down/menu down(-) button
8. MODE(MODE) Button &
LOUDNESS(LOUD) button
9. Mute(MUTE) Button &
PAUSE,PLAY( ) button
10. Audio select(SEL) button
11. EQ (Preset Equalizer) Button
12. BAND(BND) Button & Track Repeat
ON/OFF(RPT) button
13. TUNING KNOB
14. STEREO/MONO Button & Track
INTRO ON/OFF (INT) button
15. LOC/DX Button & Track Random
ON/OFF (RDM) Button
16. TRACK DOWN/REVERSE
BUTTON( )
17. TRACK UP/FAST FORWARD
BUTTON( )
18. AUXILIARY INPUT JACK
Page 2