Network Function; Connecting To The Network - Sharp Aquos LC-60LE835X Operation Manual

Network function

Connecting to the network

To enjoy internet services, you need to connect the
TV to a router with a high speed connection to the
internet. You can also connect the TV to your Home
network server through a router or access point. The TV
connection to the router can either be wired or wireless.
NOTE
• If you choose a wired connection to the router, you need an
ETHERNET cable (commercially available).
• If you do not have a broadband internet connection, consult
the store where you purchased your TV or ask your internet
service provider or telephone company.
• An ETHERNET and wireless connection cannot be used at
the same time. Use only one of the connection types.
• A stable connection speed is required to play back streaming
content, otherwise you may not be able to watch normally.
Wired installation
Use an ETHERNET cable to connect the ETHERNET
terminal on the TV to your broadcast router as shown
below. This is recommended when enjoying services
which require stable connection speeds, such as
streaming media.
E
Wired connection overview

PC (home network server)

Router (commercially available)

ETHERNET cable (commercially available)

Network
E
How to connect
Router
LAN

ETHERNET cable (commercially available)
1
Switch on the router (commercially available).
Refer to the router's operation manual for
switching on.
2
Connect the ETHERNET terminal on the TV to the
router (commercially available) with an ETHERNET
cable (commercially available).
3
Go to "HOME" > "Network setup" > "Connection
type".
4
Press c/d to select "Wired", and then press
A.
• The wired connection will be automatically established.
To change the settings manually, go to "HOME"
>
"Network setup" "IP setup" and follow the on-screen
instructions and the operation manual of the router.
TV
Connection type
Wireless setup
Setting Ethernet info.
IP setup
IP Control setup IP address
Netmask
Gateway
DNS
MAC address
5
Select "OK" to confirm.
• If you have failed to connect to the internet in the above
operation, an error message will appear. In this case,
press INPUT to return to the normal TV screen and
check the relevant settings.
ETHERNET terminal
>
[Current setup]
: Auto
: Auto
: Auto
: Auto
: xx xx xx xx xx xx
Change Initialize
45