Attaching The Stand Unit - 60Le835X - Sharp Aquos LC-60LE835X Operation Manual

Preparation
Attaching the stand unit – 60LE835X
• Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1
Confirm that there are screws with the stand unit.
For 60 inch models
(four long screws, four middle screws and two
short screws)
2
Attach the supporting post for the stand unit onto
the base using the long screws with a screwdriver
as shown.
Supporting
post
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
Soft cushion
4
Insert and tighten middle screws into the holes on
the rear of the TV.
8
5
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
Long screws
2
1
Middle
screws
Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten two short screws into the holes of
the stand cover.
Short screws