GE JKP30SPSS Dimensions And Installation Information

JKP30SP
GE 27" Built-In Single Wall Oven
®
Dimensions and Installation Information (in inches)
KW Rating
240V
3.4
208V 2.6
Breaker Size
240V 20 Amps
208V
20 Amps
Note: These ovens are not approved for stackable or
side-by-side installations.
Note: Cabinets installed adjacent to wall ovens must have
an adhesion spec of at least a 194°F temperature rating.
Note: For 27" built-in single ovens, if marks, blemishes or
the cutout opening is visible above the installed oven, it
may be necessary to add wood shims under the runners
and front trim until the marks or openings are covered.
10
Note: Door handle protrudes 3" from door face. Cabinets
A
and drawers on adjacent 45° and 90° walls should be
Allow 3/4"
for overlap
placed to avoid interference with the handle.
over all edges
of cutout
Electric wall ovens are not approved for installation
with a plug and receptacle. They must be hard wired in
accordance with installation instructions.
Installation Information: Before installing, consult
installation instructions packed with product for current
dimensional data.
D
32-1/2
E
For answers to your Monogram, GE Profile
®
C MIN.
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center Conduit 48-1/2" long
2" x 4" ®
or equiv.
800.626.2000.
runners
B MIN.
Suitable
G
bracing
to support
runners
F
or
™
service,
2" x 4" or
C L
equivalent
runners
18"
Over centerline
of cabinet
(must support 275 lbs.)
Cabinet 27"
A – Cabinet width required 27" min.
B – Minimum cabinet depth 23-5/8"
C – Opening width 25" min. - 25-1/4" max
D – Opening height 27-5/8" min. - 28-1/8" max.
Oven
E – Overall depth* 23-5/8"
F – Overall height with trim 29-7/8" - 30-3/4"
Overall height without trim 29"
G – Overall width 26-5/8"
*Depth including door handle is approximately 26-7/10" min. to
26-8/10" max.
10
A
Locate
junction box
either 5" MIN.
below cutout
floor or 44"
MIN. above
cutout floor
Access
from
D
adjacent
cabinet
required
Minimum
cutout location
32-1/2
from floor
C MIN.
(Minimum 15-5/8"
Conduit 48-1/2" long
from floor when 2" x 4"
installed below built-in
or equiv.
microwave oven) runners
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 5/09
Allow 3/4"
for overlap
over all edges
of cutout
B MIN.
G
to suppor
F
E
Listed by
Underwriters
Laboratories
320445
Suitable
bracing
runners