NordicTrack C 600 Treadmill Manual page 11

4. Make sure there is a Wheel Spacer (63) inside
each Front Wheel (62).
Hold a Front Wheel (62) inside the bottom of the
Right Upright (90), and insert a 3/8" x 4" Screw
(7) with a 3/8" Star Washer (13) into the Right
Upright and the Front Wheel.
Repeat this step with the Left Upright (not
shown).
5. Place a piece of packing material (A) under
the right side of the Base (94). Hold the Right
Upright (90) against the Base. Make sure not
to pinch the Upright Wire (81).
Insert two 3/8" x 4" Screws (7) with two 3/8"
Star Washers (13) into the Right Upright (90).
Partially tighten the three indicated Screws into
the Base (94); do not fully tighten the Screws
yet.
Move the packing material (A) to the left side
of the Base (94) and attach the Left Upright
(not shown) in the same way. Note: There are
no wires on the left side.
Remove the packing material (A) from under-
neath the Base (94).
4
90
13
7
63
5
13
7
11
62
90
94
A
81
7