Installing The Fritz!Card Usb; Connecting The Fritz!Card Usb To The Computer Or Hub And To The Isdn Line - AVM FRITZ!CARD USB Manual

3 Installing the FRITZ!Card USB

3 I
NSTALLING THE
3.1. Connecting the FRITZ!Card USB to the Computer
or Hub and to the ISDN Line
16
FRITZ!C
Be sure to perform the installation steps in the exact order given.
Otherwise the FRITZ!Card USB may not function correctly!
The F F F F F R R R R R ITZ!Car ITZ!Car ITZ!Car ITZ!Card U d U d U d USB
ITZ!Car d U
1. 1. 1. 1. 1. Connecting the F F F F F R R R R R ITZ!Car
• the ISDN line and
• the computer or hub;
2. 2. 2. 2. 2. Setting up a new hardware component in the operating sys-
tem and installing the driver software for the F F F F F R R R R R ITZ!Car
Windows 98 includes an ISDN Configuration Wizard. This wizard only
configures a previously installed AVM NDIS WAN CAPI driver, however.
The wizard cannot be used to install ISDN hardware or software,
nor to set up an ISDN connection.
To connect the F F F F F R R R R R ITZ!Car
• Switch on your computer and any peripheral devices al-
ready connected.
• Start by connecting the ISDN-Controller to your ISDN jack.
Take the ISDN cable supplied. The ISDN cable has an RJ45
connector at each end. Insert one end into your ISDN jack
and the other end into the socket labeled "ISDN" on the
back of the F F F F F R R R R R ITZ!Car
routed as desired.
• Now take and examine the USB cable. It has a different
connector at each end, one plug with a flat, rectangular
cross-section (called the Series A plug) and one with a
square cross-section (the Series B plug).
• Connect the flat Series A plug to the USB socket of your
computer or USB hub.
USB
ARD
SB SB installation is performed in two parts: SB
SB
ITZ!Car ITZ!Car d U d U SB SB
ITZ!Card U ITZ!Car d USB d U SB SB to
ITZ!Car ITZ!Car d U d U SB SB
ITZ!Car ITZ!Card U d U d USB SB, proceed as follows: SB
ITZ!Car ITZ!Car d U d U SB SB
ITZ!Car ITZ!Card U d U d USB SB. The six-meter cable can be SB
ITZ!Car ITZ!Car d U d U SB SB
ITZ!Card U ITZ!Car d USB d U SB SB.