Control Panel; Glass Surfaces - GE 164D2966P030 Use And Care Manual

Control Panel

It's a good idea to wipe the control panel after each
use. Clean with mild soap and water or vinegar and
water, rinse with clean water and polish dry with a
soft cloth.

Glass Surfaces

outside glass finish, use a glass cleaner.
To clean the
Rinse and polish with a dry cloth. Do not allow the
water or cleaner to run down inside openings in
the glass or the openings in the top of the oven
door while cleaning.
PROBLEM
"F-" AND A
NUMBER FLASH
IN THE DISPLAY
OVEN WILL
NOT WORK
OVEN LIGHT DOES
NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
POSSIBLE CAUSE
This is the function error code. Press the CLEARKWF pad. Allow oven to
disconnect power to the oven and call for service.
The circuit breaker in your house has been tripped, or a fuse has been blown.
Oven controls not properly set.
Light bulb is loose or defective. Tighten or replace.
The oven controls are not properly set. See the Broiling section.
The door not left ajar as recommended.
* Improper shelf position being used.
Food is being cooked on a hot pan.
* Cookware is not suited for broiling.
Low voltage. See the Broiling section.
Aluminum foil used on the broiler pan grid has not been fitted properly
and slit as recommended.
The oven controls are not properly set. See the Baking or Roasting section.
The oven thermostat needs adjustment. See the Adjust the Oven Thermostat–
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven cleansers
on the control panel—they will damage the finish.
A 50/50 solution of vinegar and hot water works well.
Metal Parts
Do not use steel wool, abrasives, ammonia or
commercial oven cleaners. To safely clean surfaces:
wash, rinse and then dry with a soft cloth.