GE 164D2966P030 Use And Care Manual page 32

OPERATING THE SELF-CLEANING OVEN
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are
usually a salt residue that cannot be removed by the
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
5. Press the STOP TIME pad.
6. Press the INCREASE or DECREASE pad
until the desired Stop Time appears in the
display.
Delay Start is setting the oven timer to start the
clean cycle automatically at a later time than the
of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow steps to prepare the oven for cleaning.
2. Press the CLEAN pad.
CLEAN
3. Press the INCREASE or DECREASE
A
pad to enter the Clean Time.
32
(continued)
If the oven is not clean after one clean cycle, repeat
the cycle.
If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
4. Press the STOP TIME pad.
"SET STOP TIME" and the
STOP
earliest Stop Time you can set
TIME
will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day.
the Clean Time is 3 hours and the time of day is
will be 9:00.
5.
Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example: If
you set Stop Time at 11:00, the oven will start clean
cycle at 8:00 and end at 11:00. The
automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the Clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven
door until the temperature drops below the lock
temperature and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the CLEAN pad for 3 seconds.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
For example: If
door latches