Chapter II: System and Network Setup
2-1 Installing the range extender/access point to your Network
Please follow the following instruction to build the network connection
between your new wireless range extender/access point and your
computers, network devices:
1. Connect the range extender/access point to ADSL modem, router, or
switch/hub in your network through the LAN port of the range
extender/access point by Ethernet cable.
2. Connect the A/C power adapter to the wall socket, and then connect it
to the 'Power' socket of the range extender/access point.
3. Please check all LEDs on the front panel. 'PWR' LED should be
steadily on, LAN LEDs should be on if the range extender/access
point is correctly connected to the ADSL modem, router or switch/hub.
If PWD LED is not on, or any LED you expected is not on, please
recheck the cabling, or jump to '4-2 Troubleshooting' for possible
reasons and solution.
8