Table Of Contents - Kenwood 762G Service Manual

TK-760G/762G
CONTENTS
General ................................................................. 2
System Set-Up ..................................................... 4
Operating Features ......................................... 5
Realignment ...................................................... 10
Installation ...................................................... 20
Circuit Description ......................................... 24
Semiconductor Data ..................................... 29
Description Of Components ....................... 31
Parts List ............................................................ 33
Exploded View .................................................. 42
PACKING ................................................................ 44
Adjustment ....................................................... 45
Pc Board Views
Display Unit (X54-3270-10) : Tk-760G ........ 54
Display Unit (X54-3280-10) : Tk-762G ........ 55
Pll/Vco (X58-4670-Xx) .................................. 56
Tx-Rx Unit (X57-5950-Xx) (A/2) ................... 57
Tx-Rx Unit (X57-5950-Xx) (B/2) .................... 63
Schematic Diagram ........................................ 67
Block Diagram.................................................. 75
Level Diagram ................................................... 78
Terminal Function ......................................... 80
Specifications ................................................... 81
2
CONTENTS / GENERAL
GENERAL
INTRODUCTION
SCOPE OF THIS MANUAL
cians familiar with similar types of commercial grade com-
munications equipment. It contains all required service in-
formation for the equipment and is current as of the publica-
tion date. Changes which may occur after publication are
covered by either Service Bulletins or Manual Revisions.
These are issued as required.
ORDERING REPLACEMENT PARTS
tion, the full part identification number should be included.
This applies to all parts : components, kits, or chassis. If the
part number is not known, include the chassis or kit number
of which it is a part, and a sufficient description of the re-
quired component for proper identification.
PERSONNEL SAFETY
nel safety :
• DO NOT transmit if someone is within two feet (0.6
• DO NOT transmit until all RF connectors are verified se-
• SHUT OFF and DO NOT operate this equipment near
• All equipment should be properly grounded before
• This equipment should be serviced by a qualified techni-
PRE-INSTALLATION CONSIDERNATIONS
1. UNPACKING
for accessory items. If any item is missing, please contact
KENWOOD immediately.
2. LICENSING REQUIREMENTS
dio installation (mobile or base) be obtained by the equip-
ment owner. The licensee is responsible for ensuring trans-
mitter power, frequency, and deviation are within the limits
permitted by the station license.
censed technician holding an FCC first, second or general
class commercial radiotelephone operator's license. There
is no license required to install or operate the radio.
This manual is intended for use by experienced techni-
When ordering replacement parts or equipment informa-
The following precautions are recommended for person-
meter) of the antenna.
cure and any open connectors are properly terminated.
electrical blasting caps or in an explosive atmosphere.
power-up for safe operation.
cian only.
Unpack the radio from its shipping container and check
Federal regulations require a station license for each ra-
Transmitter adjustments may be performed only by a li-