Advertisement
—
—
To replace hood lamp, first
disconnect power at
n'mhl fuse or ch'clm !'mWker panel or pull plug.
Remove 2 screws from each side of lower panel,
steady
the smoke and spatter shield with cmi hand
while removing and replacing the 2 screws on each
side. Then remove the 3 screws from front edge.
Lower the panel until it rests on range below. Place
L7'
-A
:-
'" .:
o
—=====—_—
To replaee your oven lamp, first disconnect power at
main fuse or circuit Im3aker or pull phqg.
i?emov~the
top grill by taking off 2 screws which hold it in place,
Next, remove the single screw cm top left that
secures lamp housing, (On models so equipped,)
Open oven door for easier removal of the lamp hous-
ing assembly,Then grasp tab and pull out and up to
clear door hinge and front lip of oven, To remove
bulb, push it inward gently and t~rri to left, then pull
outward from socket, Replace with GE Lamp
x 25T8DC,
00 not attempt to operate the oven unless the grill is
in pkim.
..— ...
fingers on tap near each end of lamp. Press down
and roll top of lamp gently toward front until it stops.
Remove.Replace with same type and wattage lamp.
Hold lamp near each end and insert prongs in
sockets. Gently roll top of lamp toward rear of range
until it stops, Raiselower panel and replace screws.
Clean off the grease and dust cm hood surfaces
often, Use a warm detergent solution. About 1 table-
spoon of ammonia may be added to the water, Take
care not to touch the fiiters and enameled surfaces
with this. Ammonia will tend to darken metal, Wash
the smoke and spatter shield with a warm detergent
solution,
29
—
Advertisement
