Starting The Engine - Preparation/Starting Procedure - Honda NT700V Owner's Manual

Preparation
Before starting, insert the key, turn the ignition
switch ON and confirm the following:
•
The immobilizer system (HISS) indicator is
OFF.
•
The transmission is in neutral
(neutral indicator is ON).
•
The engine stop switch is at
•
The low oil pressure indicator is ON.
•
The PGM-FI malfunction indicator lamp
(MIL) is OFF.
•
The ABS indicator light is ON. (NT700VA).
The low oil pressure indicator should go off a
few seconds after the engine starts. If the low
oil pressure indicator lights during operation,
stop the engine immediately and check the
engine oil level.
NOTICE
Operating the engine with insufficient oil
pressure can cause serious engine damage.
78
Starting Procedure
This motorcycle has a fuel-injected engine
with an automatic choke. Follow the procedure
indicated below.
Any Air Temperature
1. With the throttle completely closed, press
(RUN). the start button.
The engine will not start if the throttle is fully
open (because the electronic control module
cuts off the fuel supply).
Snapping the throttle or fast idling for more
than about 5 minutes at normal air
temperature may cause exhaust pipe
discoloration.