DeLonghi DEs02 series Instructions For Use Manual page 9

To make espresso after frothing milk
Important - Never remove the filter holder from its
housing immediately after using the steam fuction.
if you're making espresso after frothing milk, you need to
get rid of any over-hot water that could burn your coffee.
here's how:-
1 switch off the steam button.
2 ensure there is water in the tank and place a jug beneath
the steam nozzle.
3 open the variable steam knob by turning anti-clockwise
and press the coffee button (water/steam will come out
of the steam nozzle). Wait until the green light flashes
then close the variable steam knob and switch off the
coffee button.
4 Wait for additional time until the green light glows con-
tinuously. When this happens the machine is ready to
make coffee.
Cleaning
Steam nozzle
Prior to cleaning the steam nozzle allow some hot water to
flow out of the nozzle to assist with the cleaning operation.
This should be carried out immediately after having dispensed
steam. here's how:-
1 ensure there is water in the tank and that there is a jug
under the steam nozzle.
2 switch off the steam button.
3 open the steam knob by turning in an anti-clockwise
direction.
4 Press the coffee button and operate for approximately 10
seconds to allow hot water to pass through the nozzle.
5 switch off the coffee button then close the variable steam
knob by turning clockwise.
6 Press the on/off button to switch off the machine.
Before further cleaning, unplug and let everything cool.
Never immerse the appliance in water.
Don't wash parts in the dishwasher unless recommended.
Steam nozzle
1 Unscrew the nozzle by turning clockwise, then wash thor-
oughly. check that the 3 holes indicated are not blocked.
if necessary unblock them with a pin.
2 clean the steam tube. Make sure the end is not blocked.
3 screw the nozzle back onto the delivery tube.
Tank, lid, filter holder
Wash, rinse and allow to dry.
Filter (one and two cup version)
Wash and dry after every use.
After approximately every 100 uses dismantle and clean more
thoroughly as described below.
Remove the cap located on the underside of the filter by turn-
ing in the direction indicated 6. Remove the crema device by
pushing up from the underside 7. separate the components of
the crema device by pulling the gasket to the side and remov-
ing the plastic disc and metal filter. Rinse parts thoroughly.
clean the metal filter in hot water using a brush 8. Make sure
the holes in the metal filter are not blocked. if necessary clean
with a pin 8. Dry the parts then reassemble, making sure the
parts are correctly assembled.
Cup stand, drip tray
empty the drip tray regularly. you'll know when it is full, the
red float in the middle of the drip tray will rise and become
visible in the hole on the cup stand.
1 Wash then dry. Alternatively wash in the dishwasher, first
removing the float from the drip tray and placing in the
cutlery basket.
Coffee outlet
After every use check that this area is clean and free from any
coffee grounds. Wipe clean and if necessary carry out the fol-
lowing procedure to clean more thoroughly. failure to keep
this area clean will affect the quality of the coffee produced
and may damage the unit.
1 Using a screwdriver 10, unscrew the screw that holds the
coffee outlet in place (do not remove the inner cover).
2 clean the area with a damp cloth.
3 clean the removed outlet thoroughly in hot soapy water
using a brush. Rinse thoroughly. Make sure the holes are
not blocked, if necessary use a pin to clean.
4 Reverse the above procedure to re fit to the outlet.
failure to clean the coffee outlet and the filters as de-
scribed invalidates the guarantee.
failure to clean the coffee outlet and the filters as described
invalidates the guarantee.
Descaling
it is advisable to discale the coffee maker after 200 cups of cof-
fee have been made.
1 We recommend purchasing a product specifically for des-
caling espresso coffee machines. Use the quantities rec-
ommended by the proprietary descaler but do not exceed
the 1 litre tank capacity.
2 Make sure the filter holder is not attached and position a
bowl under the coffee outlet and a jug under the steam
nozzle.
3 Press the on/off button then press the coffee button and
open the variable steam knob by turning anti-clockwise
8
en
Descaling