Problem Solver - GE Spacemaker JVM140K User Manual

PROBLEM
OVEN W~L NOT COME
ON
CONTROL PANEL
WILL NOT START
ON DISPLAY
FLOOR OF THE
OVEN IS WARM,
EVEN WHEN THE
OVEN HAS NOT
BEEN USED
Steam or vapor escaping from around the door.
Dimming oven light and change in blower sound
occur while operating at power levels other
may
than high.
If you need more help...call, toll free: GE Answer Center
32
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
A fuse in your home may be blown or the circuit breaker tripped. Replace
or reset circuit breaker.
Unplug your microwave oven, then plug it back in.
Door not securely closed.
START pad must be touched after entering cooking selection.
Another selection entered already in oven and CLEANOFF pad not touched
to cancel it.
Make sure you have entered cooking time after touching TIME COOK I & 11
pad.
START pad.
Make sure you have entered a temperature after touching TEMP COO~OLD
pad.
Make sure you have entered a code number after touching AUTO ROAST pad.
Probe has been forgotten or not seated properly in oven wall when using Temp
The cooktop lamp is located directly below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is norrnd.
Dull thumping sound while oven is operating.
Some TV-Radio interference might be noticed
while using your microwave oven. It's similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
@
/ 800.626.2000/ consumer information service
fuse