GE JVM1190 Owner's Manual page 46

About light bulb replacement.
Remove screw
46
Cooktop Light/Night Light
To replace combination cooktop light/night light,
1
first disconnect the power at the main fuse or circuit
breaker panel or pull the plug.
Remove the screw on the right side of the light
2
compartment cover and lower the cover until it stops.
Be sure the bulb(s) to be replaced are cool
3
before removing. Break the adhesive seal by
gently unscrewing the bulb(s).
Replace with 40-watt incandescent bulbs. Order WB02X4253
from your GE supplier. High-intensity 40-watt bulbs (40S11N/1),
available in supermarkets and hardware stores, may also be
used for replacements.
Raise light compartment cover and replace the
4
screw. Connect electrical power to the oven.
Oven Light
To replace the oven light, first disconnect the power
1
at the main fuse or circuit breaker panel or pull the plug.
Remove the top grille by taking out the screw that
2
holds it in place.
Next, remove the single screw located above the
3
door near the center of the oven that secures the
light housing.
Replace the burned-out bulb with a 40-watt incandescent bulb
(WB02X4253), available from your GE supplier.