Removing/Installing/ The Camber Tube; Removing The Camber Tube; Installing The Camber Tube - Invacare Crossfire T6 Owner's Operator And Maintenance Manual

Removing/Installing/ the Camber Tube

Camber tube mounting clamps - Make sure the mounting screws are securely
tightened before using the wheelchair, otherwise personal injury or damage to the
wheelchair may occur.
NOTE: For this procedure, refer to FIGURE 8.11.
NOTE: When replacing or changing the camber tube, perform with the new camber tube.

Removing the Camber Tube

1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 40.
2. Loosen the two socket screws securing camber tube to the two camber tube mounting
brackets.
3. Slide the camber tube from the camber tube mounting brackets.

Installing the Camber Tube

1. Insert the camber tube into the camber tube mounting brackets.
2. Center the camber tube in the camber tube mounting brackets.
3. Loosen the two socket screws securing camber tube to the two camber tube mounting
brackets.
4. Adjust the camber tube. Refer to Adjusting the Camber Tube on page 50.
FIGURE 8.11 Adjusting Wheelbase Length (Adjusting Center of Gravity)
Part No 1134872
WARNING
Socket Screw
Socket Screw
camber
Tube
camber Tube
Mounting Bracket
49
SECTION 8—WHEELS
™
Crossfire Series Wheelchairs