Procedure 12 - Wheels/Motors; Replacing Pneumatic Tires/Tubes - Drive Wheels/Casters; Removing/Installing Drive Wheels - Invacare Arrow RWD Service Manual

WHEELS/MOTORS
This Procedure includes the following:
Replacing Pneumatic Tires/Tubes - Drive Wheels/
Casters

Removing/Installing Drive Wheels

Removing/Installing Drive Wheel Hub
Installing Wheel Lock Bracket onto Wheelchair
Removing/Installing Casters
Replacing Forks
Motor Replacement
W W W W W ARNING ARNING ARNING ARNING
ARNING
After ANY adjustments, repair or service and BEFORE
use, make sure all attaching hardware is tightened
securely - otherwise injury or damage may result.
C C C C C A A A A A UTION
As with any vehicle, the wheels and tires should
be checked periodically for cracks and wear
and should be replaced.
REPLACING PNEUMATIC TIRES/
TUBES - DRIVE WHEELS/CASTERS
WARNING
DO NOT use your wheelchair unless it has the
proper tire pressure (p.s.i.). DO NOT overinflate the
tires. Failure to follow these suggestions may cause
the tire to explode and cause bodily harm.
If tires are pneumatic, replacement of tire or tube
MUST be performed by an authorized Invacare
dealer or qualified technician.
NOTE: If drive wheels or casters are pneumatic, under-in-
flation causes excessive wear which results in poor perfor-
mance of the tires.
REMOVING/INSTALLING DRIVE
WHEELS (FIGURE 1)
CAUTION
Perform the following procedure in a designated
work area to prevent damage to flooring (car-
peting, tile, etc.).
Removing
1. Remove the battery box(es). Refer to INSTALLING/
REMOVING GROUP 24 BATTERY BOXES or IN-
STALLING/REMOVING GROUP 22 BATTERY
BOXES in PROCEDURE 9 of this manual.
UTION UTION UTION UTION
2. Remove the four (4) beveled hex nuts that secure the
drive wheel assembly to the drive wheel hub assembly/
GB motor spacer.
3. Remove existing drive wheel assembly from wheel hub.
Installing
1. Reinstall new/existing drive wheel assembly to
the wheel hub assembly and torque the four (4)
beveled hex nuts to 160-inch pounds.
2. Repeat procedure for opposite side of wheelchair,
if necessary.
3. Reinstall the battery box(es). Refer to INSTALL-
ING/REMOVING GROUP 24 BATTERY BOXES
or INSTALLING/REMOVING 22NF BATTERY
BOXES in PROCEDURE 9 of this manual.
CONVENTIONAL MOT T T T T OR CONVENTIONAL MO CONVENTIONAL MO
CONVENTIONAL MO CONVENTIONAL MO
Drive Wheel
Assembly
Four (4)
Beveled
Hex Nuts
GEARLESS/BR GEARLESS/BR
GEARLESS/BR GEARLESS/BRUSHLESS MO GEARLESS/BR
Drive Wheel
Assembly
Four (4) Beveled Hex Nuts
FIGURE 1 - REMOVING/INSTALLING DRIVE WHEELS
AND DRIVE WHEEL HUB
57
PROCEDURE 12
OR OR WITH GEARBO WITH GEARBOX X X X X WITH GEARBO
OR WITH GEARBO OR WITH GEARBO
Motor/Gearbox
Assembly
Drive Wheel
Hub
USHLESS MOT T T T T OR USHLESS MO USHLESS MO OR OR
USHLESS MO OR OR
Drive Wheel
Hub
GB Motor
Spacer
W
H
E
E
L
S
/
M
O
T
O
R
S