Replacing Battery Charger Bracket And T-Nut; Removing/Installing Seat Stop Screws - Invacare Arrow RWD Service Manual

PROCEDURE 7
12. Reinstall the seat mount plates. Refer to REPLACING
SEAT MOUNTING PLATES in this procedure of the
manual.
13. Adjust seat mounting plates to desired angle. Refer to
MOUNTING PLATE - SEAT ANGLE ADJUSTMENT
B
AND INSTALLATION ORIENTATION in PROCEDURE
A
6 of this manual.
S
14. Reverse STEP 2A, 2B or 2C.
E
15. Perform the instructions outlined in PREPARATIONS
F
FOR REMOVING/INSTALLING SEAT FRAME (STAN-
R
DARD FRAME, ADJUSTABLE FRAME, AND CAP-
TAINS VAN SEAT) in PROCEDURE 6 of this manual.
A
M
REPLACING BATTERY CHARGER
E
BRACKET AND T-NUT (FIGURE 4)
NOTE: For 3G wheelchairs equipped with 2G pow-
ered seating systems only.
1. Perform the instructions outlined in PREPARATIONS
FOR REMOVING/INSTALLING THE SEAT FRAME
(STANDARD FRAME, ADJUSTABLE FRAME, AND
CAPTAINS VAN SEAT) in PROCEDURE 6 of this
manual.
2. Remove one (1) of the following: (Refer to Procedure
6)
A. Standard seat frame subassembly.
B. Adjustable seat frame subassembly.
C. Captains van seat.
3. Remove the seat support brackets. Refer to RE-
PLACING SEAT SUPPORT BRACKETS in this
procedure of this manual.
4. Remove the two (2) mounting screws that secure the
battery charger connector to the mount bracket.
5. Remove battery charger connector from mount bracket.
6. Remove the mounting screw which secures the battery
charger mount bracket to the T-nut located in the chan-
nel of the base frame.
7. Replace battery charger mount bracket and secure to
base frame with existing mounting screw.
NOTE: To replace the Battery Charger Bracket T-Nut, per-
form STEPS 3-13 in REPLACING SEAT SUPPORT
BRACKET T-NUTS in this procedure of the manual.
8. Secure the battery charger connector to the mount
bracket with the EXISTING two (2) mounting screws.
Tighten securely.
9. Reverse STEP 2A, 2B or 2C.
10. Perform the instructions outlined in PREPARATIONS
FOR REMOVING/INSTALLING SEAT FRAME (STAN-
DARD FRAME, ADJUSTABLE FRAME, AND CAP-
TAINS VAN SEAT) in PROCEDURE 6 of this manual.
Mounting Screw
Battery
Charger
Mount
Bracket
Base
Frame
FIGURE 4 - REPLACING BATTERY CHARGER BRACKET
AND T-NUT
REMOVING/INSTALLING SEAT
STOP SCREWS (FIGURE 5)
NOTE: The front seat stop screw should only be removed
if replacing a T-nut for either the seat support bracket or
the battery charger mount bracket. The rear seat stop
screw should never be removed.
1. Unthread seat stop screw from base frame.
WARNING
The seat stop screws must be in place before op-
eration of your power wheelchair. Ensure the seat
support bracket is positioned between both seat
stop screws.
2. When reinstalling the front seat stop screw, ensure
the seat support bracket is located in-between both
seat stop screws. Use loctite 242 and tighten securely.
Seat Support Bracket
Base
Frame
FIGURE 5 - REMOVING/INSTALLING SEAT STOP
34
BASE FRAME
Battery
Charger
Connector
Rear Seat
Stop Screw
Front Seat Stop Screw
SCREWS
T-Nut