Resolved Caveats - HP Cisco Catalyst Blade Switch 3020 Release Note

Cisco gigabit ethernet switch module for hp bladesystem p-class release notes cisco ios release 12.2(44)se1 and later
Hide thumbs Also See for Cisco Catalyst Blade Switch 3020:
Table of Contents

Advertisement

Resolved Caveats

Open Device Manager Caveats
This is the severity 3 device manager caveat for this release:
Resolved Caveats
This section describes the caveats that have been resolved in these releases:
Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
16
CSCef94061
If you enter the letter i by itself in the port description, the VLAN status column displays i; this only
occurs when you are using Device Manager through Netscape 7.1.
The workaround is to run Device Manager through Internet Explorer if you must enter a port
description with only the value "i."
"Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5" section on page 16
"Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE3" section on page 17
"Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE2" section on page 17
"Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE1" section on page 18
"Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE" section on page 21
CSCsd73245
Excessive IPRT-3-PATHIDX error messages no longer appear in the log file.
CSCsf10850
When configuring an IP SSH version 2 connection, you can no longer create an RSA key that is less
than 768 bits.
CSCso63475
A switch now boots correctly after a software reload or power cycle. In previous releases, under
some rare circumstances, the image would be truncated to zero bytes and the switch would not boot.
CSCsu10229
The cdpCacheAddress value now appears in a GLOBAL_UNICAST address.
CSCsu40077
The switch now correctly processes ingress traffic when a port is configured with a short 802.1x
tx-period timer value (such as dot1x timeout tx-period 3).
CSCsu47056
The username is now properly logged when the remote command privileged EXEC command is
used to configure a cluster member.
464831-005

Advertisement

Table of Contents
loading

Table of Contents