HP Carrier-grade cc2300 Start Manual page 21

Warning: English (US) (continued)
A microprocessor and heat sink might be hot if the system has been running. Also, there
might be sharp pins and edges on some board and chassis parts. Contact should be made
with care. Consider wearing protective gloves.
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries ac-
cording to manufacturer's instructions.
The system is designed to operate in a typical office environment. Choose a site that is:
· Clean and free of airborne particles (other than normal room dust).
· Well-ventilated and away from sources of heat including direct sunlight.
· Away from sources of vibration or physical shock.
· Isolated from strong electromagnetic fields produced by electrical devices.
· Protected when in regions that are susceptible to electrical storms. We recommend you
plug your system into a surge suppresser and disconnect telecommunication lines to your
modem during an electrical storm.
· Provided with a properly grounded wall outlet.
· Provided with sufficient space to access the power supply cords, because they serve as
the product's main power disconnect.
Servers can be too heavy for a single person to lift or move safely. Depending on the server,
use two people or a mechanical assist to lift or move the server.
HP cc2300 Carrier Grade Server Quick Start Guide 21