Electrostatic Discharge (Esd) Precautions; Lithium Battery Caution; Laser Safety - HP Integrity BL860c Safety And Regulatory Information Manual

Electrostatic Discharge (ESD) Precautions

When handling any electronic component or assembly (such as a PCI card or memory DIMM),
you must observe the following antistatic precautions to prevent damage. An ESD kit (HP P/N
A3024-80004) is available (or supplied with memory additions). This kit contains one wrist strap,
one conductive sheet, and one antistatic foam pad.
Always disconnect power from the server and wear a grounded wrist strap when working
around the server.
Always wear a grounded wrist strap when handling printed circuit boards.
Treat all assemblies, components and interface connections as static-sensitive.
Avoid working in carpeted areas, and keep body movement to a minimum while removing
or installing boards, to minimize buildup of static charge.

Lithium Battery Caution

WARNING!
of explosion if battery is installed incorrectly.
Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions and local disposal requirements.
IMPORTANT:

Laser Safety

NOTE: Laser devices installed in this equipment must be certified as Class 1 Laser devices by the
Regulatory Agency recognized by the country where the equipment is installed.
NOTE: If a Fibre Channel I/O card is present, the following laser safety statement applies.
This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre
communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained
in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The
certification is indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements
contained in IEC 60825- 1 :1993 and EN 60825- 1 :1994, including Amendment 1 1:1996.
NOTE: If a DVD is present, the following laser safety statement applies.
This product contains a laser internal to the Digital Versatile Disc (DVD) housing.
In the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained
in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The
certification is indicated by a label on the DVD housing.
Outside the USA, the DVD is certified as a Class 1 laser product conforming to the requirements
contained in IEC 60825- 1 :1993+A1 and EN 60825- 1 :1994+A1 1.
Observe the correct polarity when changing the lithium battery. There is a danger
Switzerland: Annex 4.10 of SR 814.013 applies to batteries.
Overview 5