GE DSXH47GG Dimensions And Installation Information page 2

DSXH47GG
GE 5.8 Cu. Ft. Extra-Large Capacity Frontload Gas Dryer
®
Special Installation Requirements:
Stacked Installation:
• B racket for stacking dryer, DSXH47EG/GG, order Pub. No. 14-A026 or STACKIT1WW at additional cost.
Undercounter installation:
• T he WSSH300G and DSXH47EG/GG require a custom-sized countertop (36 inches to the underside of the countertop).
No special washer or dryer top is required.
Alcove or Closet Installation:
• I f your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• M inimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• C loset doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally
distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area
equally distributed.
• N o other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• T he installation must conform with the local codes, or in the absence of
local codes, with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides, 3" rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
For answers to your Monogram, GE Profile
®
or GE ® appliance questions, visit our website
at geappliances.com or call GE Answer Center
service, 800.626.2000.
™
®
Specification Revised 3/10
360471