Sleep Mode; Guard Modes - WowWee Roboboa User Manual

Sleep mode / Guard modes
Even if you interact with your Roboboa once the alarm is set, he'll interrupt
whatever he's doing to play the alarm. If you need your robot to remind you to
go somewhere in two hours (for example), you can still use him as a light or for
fun and he'll remember to activate his alarm.
Note: To clear your alarm, wake up your Roboboa by pressing Stop, then press
Reset (hold the Tail / Head button for more than 2 seconds), or execute a
Shutdown command (hold the Mode button then press Stop within 2 seconds),
or power your robot Off from the power button in his tail.
When his alarm goes off, you can turn him off or Stop by pressing any Mode
button.

Sleep mode

Put Roboboa to sleep so you can carry him around and all his programs and
alarm settings will be remembered.
Function Button combination
Sleep Press and hold the
Explore button for
more than 2 seconds
CAUTION:
If you have set an alarm, he will wake up on his own, so do not
position him where he will hit things upon waking.
NOTE:
If left asleep for more than 24 hours, he will enter Shutdown mode
and all programs and settings will be lost unless you have pressed Daily. (See
page 15)

Guard modes

Roboboa can be used as a vigilant guard that can "protect" your desk, shelf, or
doorway. Guard mode scans a room from left to right at about 45 degrees on
each side, and to a range of several feet.

Description
Roboboa yawns and then folds
himself into his sleep position.
NOTE:
Before activating any guard mode, be sure to place him on an open
surface or floor.
To activate the Guard mode, press the Guard button. When your Roboboa
enters guard mode, he first "loads" himself up, then starts to scan the room
for objects.
The following table outlines the Guard mode functions from the remote
controller:
Function Button combination
Guard Press the Guard button
Sentry Press and hold the
Guard button for more
than 2 seconds
Patrol Hold the Mode
button then press the
Guard
button within 2
seconds
Description
NOTE: This function times out after
about 2 hours, then re-enters Aware
mode.
A spin-in-place-shooting mode,
your robot scans the nearby area for
intruders and objects. Anything that
falls within several feet of his face
gets ray-beamed.
After 12 shots, he reloads himself
and will start to spin the other way
NOTE: Sentry mode times out after
about 20 minutes, then re-enters
Aware mode.
A roving patrol robot that cannon-
rounds anything that comes within
several feet as he moves around.
After 4 shots, he'll turn around and
rove in another direction.
NOTE: Patrol stops after about 10
minutes, then re-enters Aware mode.