Configuring Basic Ipv6 Functions; Enabling Ipv6; Configuring An Ipv6 Global Unicast Address - HP 6125G Configuration Manual

Layer 3 - ip services configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Configuring basic IPv6 functions

Enabling IPv6

Enable IPv6 before you perform any IPv6-related configuration. Without IPv6 enabled, an interface
cannot forward IPv6 packets even if it has an IPv6 address configured.
To enable IPv6:
Step
1.
Enter system view.
2.
Enable IPv6.

Configuring an IPv6 global unicast address

Configure an IPv6 global unicast address by using the following options:
EUI-64 IPv6 addressing—The IPv6 address prefix of an interface is manually configured, and the
interface identifier is generated automatically by the interface.
Manual configuration—The IPv6 global unicast address is configured manually.
Stateless address autoconfiguration—The IPv6 global unicast address is generated automatically
based on the address prefix information contained in the RA message.
Follow these guidelines when you configure an IPv6 global unicast address:
You can configure multiple IPv6 global unicast addresses with different prefixes on an interface.
A manually configured global unicast address takes precedence over an automatically generated
one. If a global unicast address has been automatically generated on an interface when you
manually configure another one with the same address prefix, the latter overwrites the previous. The
overwritten automatic global unicast address will not be restored even if the manual one is removed.
Instead, a new global unicast address will be automatically generated based on the address prefix
information in the RA message that the interface receives at the next time.
EUI-64 IPv6 addressing
To configure an interface to generate an EUI-64 IPv6 address:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure the interface to
generate an EUI-64 IPv6
address.
Manual configuration
To specify an IPv6 address manually for an interface:
Command
system-view
ipv6
Command
system-view
interface interface-type
interface-number
ipv6 address
ipv6-address/prefix-length
eui-64
88
Remarks
N/A
Disabled by default
Remarks
N/A
N/A
By default, no IPv6 global unicast
address is configured on an interface.

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents