Configuration Guidelines; Configuration Procedure - HP 6125G Configuration Manual

Layer 3 - ip services configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

If the virtual IP address of the VRRP group is associated with a virtual MAC address, the sender
MAC address in the gratuitous ARP packet takes the virtual MAC address of the virtual router. If the
virtual IP address of the VRRP group is associated with the real MAC address of an interface, the
sender MAC address in the gratuitous ARP packet takes the MAC address of the interface on the
master router in the VRRP group.
For more information about VRRP, see High Availability Configuration Guide.

Configuration guidelines

Follow these guidelines when you configure gratuitous ARP:
You can enable periodic sending of gratuitous ARP packets in VLAN interface view.
You can enable periodic sending of gratuitous ARP packets on a maximum of 512 interfaces.
Periodic sending of gratuitous ARP packets takes effect only when the link of the enabled interface
goes up and an IP address has been assigned to the interface.
If you change the interval for sending gratuitous ARP packets, the configuration is effective at the
next sending interval.
The frequency of sending gratuitous ARP packets may be much lower than is expected if this
function is enabled on multiple interfaces, if each interface is configured with multiple secondary IP
addresses, or if a small sending interval is configured in such cases.

Configuration procedure

To configure gratuitous ARP:
Step
1.
Enter system view.
2.
Enable learning of gratuitous
ARP packets.
3.
Enable the device to send
gratuitous ARP packets upon
receiving ARP requests from
another subnet.
4.
Enter interface view.
5.
Enable periodic sending of
gratuitous ARP packets and set
the sending interval.
Command
system-view
gratuitous-arp-learning
enable
gratuitous-arp-sending
enable
interface interface-type
interface-number
arp send-gratuitous-arp
[ interval milliseconds ]
11
Remarks
N/A
Optional.
Enabled by default.
By default, a device does not send
gratuitous ARP packets upon
receiving ARP requests from another
subnet.
N/A
Disabled by default.

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents