Multicast Arp Configuration Example - HP 6125G Configuration Manual

[Switch-GigabitEthernet1/0/1] port link-type trunk
[Switch-GigabitEthernet1/0/1] port trunk permit vlan 10
[Switch-GigabitEthernet1/0/1] quit
# Create interface VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 24
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface GigabitEthernet 1/0/1 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 GigabitEthernet 1/0/1
# Display information about static ARP entries.
[Switch] display arp static
IP Address
192.168.1.1

Multicast ARP configuration example

Network requirements
As shown in
cooperate with NLB, configure the following:
Add GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 into VLAN 1, and specify IP address
•
16.1.1.30/24 for VLAN-interface 1.
• Add GigabitEthernet 1/0/1 and GigabitEthernet 1/0/4 into VLAN 2, and specify IP address
17.1.1.1/24 for VLAN-interface 2.
Specify 17.1.1.1/24 as the default gateway of Host A and Host B.
•
Specify 16.1.1.30/24 as the default gateway of Server A and Server B.
•
Disable the ARP entry check function so that the switch can learn dynamic ARP entries containing
•
multicast MAC addresses.
Configure a static multicast MAC address entry so that only interfaces GigabitEthernet 1/0/2 and
•
GigabitEthernet 1/0/3 can receive multicast information.
Figure 5 Network diagram
Type: S-Static
MAC Address
00e0-fc01-0000
Figure 5, a small data center uses Microsoft multicast-mode NLB. To enable the switches to
D-Dynamic A-Authorized
VLAN ID Interface
10 GE1/0/1
8
Aging Type
N/A S